Table of Contents
Advertisement
CoDeSys PLC
3. Ensure that the Station address: for PROFIBUS specified under tab DP parameters is
correct
The Station address: is automatically generated for the first node. This entry should
match the node address set on the PROFIBUS slave DIP switches.
4. Assign variables to the addresses of the fieldbus I/O modules and use the variable
names in the application. (e.g. PROFIBUS output with variable name: PROFIBUS_OUT
and PROFIBUS input with the variable name: PROFIBUS_IN)
PROCEDURE END: Configuring fieldbus - PROFIBUS DP Master - now complete
Page 24
PROGRAMMING ASSISTANCE GUIDE
© 2007 Kontron Modular Computers GmbH
ThinkIO
™
- P
ID 29867.06, Rev. 01
Advertisement
Table of Contents
