Providing A Route Between The Windows Host Pc And The Thinkio-P - Kontron ThinkIO-P Manual

ThinkIO ™ - P
LOCAL HOST PC
GATEWAY
SWITCH/HUB
THINKIO-P
If the IP address of the ThinkIO-P is known and it is required to change the address, the
ThinkIO-P maybe accessed via Web Based Management. In any event, the IP address of the
ThinkIO-P is required to download a CoDeSys application.
4.2 Providing a Route Between the Windows Host PC and the
ThinkIO-P
If the host PC and the ThinkIO-P reside in two different networks, a logical route between the
networks must be established. This is accomplished using the DOS line command "route" on
the Windows host PC.
In the following example, 192.168.52.220 is the IP address of the ThinkIO-P, and the address
of the gateway for this network is 193.102.136.40. The command is as follows:
route ADD 192.168.52.220 MASK 255.255.255.0 193.102.136.40
target
To verify the communication path, issue a "ping" command.
ID 29867.06, Rev. 01
PROGRAMMING ASSISTANCE GUIDE
IP Address:
Sub-netmask:
IP Address:
Note: The gateway may or may not be
present in this configuration.
IP Address X9: 192.168.0.50
Sub-netmask: 255.255.255.0
Standard Network Configuration
sub-netmask gateway
© 2007 Kontron Modular Computers GmbH
CoDeSys PLC
192.168.1.1 (for example)
255.255.255.0
nnn.nnn.nnn.nnn
(factory setting)
Page 3