Table of Contents
Advertisement
•
Phillips head No. 2 screwdriver that is a minimum of 4 inches long
•
T20 Torx driver if using a threaded rack
•
A mechanical lift is highly recommended
Stabilize the Rack for Installation
Use this procedure to stabilize the rack before installing Oracle Database Appliance X9-2-HA.
Caution:
Personal injury or equipment damage. To reduce the risk of personal injury,
stabilize the rack cabinet, and extend all anti-tilt devices before installing the server.
Refer to your rack cabinet documentation for more detailed instructions.
When unpacking at the installation site, verify that the rack cabinet leveling feet are up
1.
before moving the rack cabinet.
Remove the front and rear doors of the rack cabinet if they interfere with the installation.
2.
To prevent the rack cabinet from tipping during the installation, fully extend the rack
3.
cabinet's anti-tilt legs or anti-tilt bar, which are located at the bottom front of the rack
cabinet.
If there are leveling feet beneath the rack cabinet to prevent it from rolling, extend these
4.
leveling feet fully downward to the floor once the rack cabinet is where it will reside in the
data center.
When moving a rack cabinet to a different location, including repacking, verify that rack
5.
cabinet leveling feet are up before moving the rack cabinet.
Apply Labels to Server Nodes
Complete this task to apply server node labels before installing the appliance into a rack.
Find the labels.
1.
The shipping kit includes server node labels. The storage shelf labels are applied at the
factory.
Verify that the locations where the labels need to go are clean, and free of grease and
2.
dirt.
Apply the labels where needed:
3.
For labels that you attach, peel off the backing sheet and apply the label to the
corresponding spot on the right-hand side of the appliance front panel.
Caution:
Personal injury or equipment damage. The storage shelf weighs
approximately 51 lbs (23 kg). If no mechanical lift is available, use three people
to place it in the rack.
Chapter 4
Installing the System Into a Rack
4-11
Advertisement
Table of Contents
