Table of Contents
Advertisement
Attach the storage shelf rails to the rack, as follows:
3.
Orient the rail so that the stamped label (LEFT or RIGHT) is facing the inside
a.
of the rack.
Adjust the rail length to fit the front and rear of the rack.
b.
Note:
Mark which rack rail holes you will be using to ensure the storage
shelf rails are installed evenly and correctly the first time.
Hold open the rail clamp at each end of the rail by pressing the clamp lever [1]
c.
and insert both ends of the rail into the appropriate rack holes [2].
The following figure shows how to fit the storage shelf rails to the rack:
Close the rail clamps over the rails by releasing the clamp lever.
d.
You will hear an audible click as the clamps lock in place over the rack rails.
Repeat steps 3a through 3d for the second rail.
e.
Install one screw through the rack and into the rear of each rail.
4.
The following figure shows how to secure the storage shelf rails to the rack:
Chapter 4
Installing the System Into a Rack
4-14
Advertisement
Table of Contents
