What Do Error Codes Mean - GE Solar 7000 Service Manual

What Do Error Codes
Mean?
Revision J
CONFIGURATION: Advanced User Procedures
The error log contains more than just operating system errors. Many
events that have an impact upon the system are also entered into the log.
The 700-series of error codes are really system initiated events. Listed
below are some of the event/error codes you might find useful.
Error Code
400-4FF Network errors were detected.
703 Diagnostic tests were completed.
70B Internet address was changed. The network address
for the monitor was changed. This should only be done
by qualified service personnel.
70C Video test was completed. This test should only be
performed by qualified service personnel.
70D Rear power switch was turned off.
70E Time was changed from this monitor. This helps
determine how the system-wide time may have been
altered.
70F Date was changed from this monitor. This helps
determine how the system-wide date was altered.
710 Incompatible software was detected. If the main
processor software finds that the software operating
on the communication software incompatible, it turns
off the communication (network) controller and enters
this data into the error log. When the monitor won't
"talk" to the network, looking for this entry in the
error log is one part of the troubleshooting process.
714 Incompatible TRAM module software was detected. If
the main processor software finds the software
revision in the TRAM is incompatible, it turns off
communication with the TRAM and enters an error
log. Refer to the software compatibility listing in the
SOFTWARE REVISION window.
NOTE
The monitor may be referred to as a display or scope in
the error code descriptions.
Solar 7000/8000/View Patient Monitor
414993-001
Definition of Parameters
Description
6-23