Diagnosis Codes / Error Codes - GE TONOPORT V Service Manual

9
Revision H
Diagnosis Codes / Error
Codes
Code
E 02 Battery depleted. Code is displayed to indicate that the battery charge
level is insufficient for further measurements. The recorder
differentiates between two states: the memory has just been cleared
(i.e., the battery test is performed with a higher power consumption to
ensure that a fresh battery will be inserted at the beginning of the
measurement) or measurements have already been taken.
E 03 Measurement time over. Code is displayed when a measurement is not
taken within 60 seconds (excluding cuff inflation time).
E 06 Inflation time over. The max. inflation time of 60 s has elapsed. This
condition indicates a leak in the cuff or tubing, or a defective gasket.
E 07 The pump will not increase the cuff pressure any further. Code is
displayed when no systolic reading could be found although the cuff
pressure was already increased twice. The measuring system waits
until the next measurement is due.
E 08 200 pressure measurements taken; storage capacity exhausted.
E 14 Diastolic reading below 40 mmHg. Code appears when the cuff
pressure has dropped to 40 mmHg and diastole could not be identified
(TONOPORT does not measure diastolic pressures below 40 mmHg).
E 15 Motion artifact during diastole detection.
E 17 Internal hardware error (inform service center).
E 18 Systolic pressure outside measuring range.
E 19 Diastolic pressure outside measuring range. (These codes are
displayed when the systolic and diastolic values are outside the range
in which oscillations have been detected. Tighten the cuff slightly.)
E 21 Difference between systolic and diastolic pressure too small (10 mmHg
or less)
E 22 Motion artifact during systole detection.
E 24 No systole detected in the provided time frame.
E 26 Systolic pressure below 60 mmHg.
TONOPORT V
2001589-023
Explanation
9-1