Table of Contents
Advertisement
BACnet Router Properties
CAUTION Do not change the settings on this page as it will result in communication failure. Use the
controller setup pages (page 42) to change settings and then resolve mismatches in the i-Vu® application.
BACnet Firewall
If this IP controller is accessible from the Internet, you can increase security by enabling its BACnet firewall. When
enabled, this feature prevents the controller from responding to BACnet messages from unidentified sources and
allows communication only with IP addresses that you define. These can be all private IP addresses and/or a list
of IP addresses. Follow the instructions in the i-Vu® interface to set up the BACnet firewall.
Network Diagnostics - Statistics
This page shows the network statistics for each of the TV-PSM's ports that are in use. This same information is
provided in a Module Status report (page 50).
Click the Error Rate Trend or Packet Rate Trend link at the bottom of each section to see the statistics displayed
as trend graphs. You can also access these trends by clicking on the driver in the network tree, and then selecting
Trends > Enabled Points > and the desired trend graph.
Click a port's Reset button to set all of the numbers to zero so the counting can start over.
Router Statistics
Error Counters
Network Activity
Router Sourced Packets
Trends
TruVu™ ChillerVu™ Plant Controller
Installation and Start-up Guide
Dropped Packets—Data packets that could not be delivered.
Route Not Found—Packets that could not be delivered because the requested
network does not exist.
Route Unreachable—These are routed packets whose destination network is
either busy or offline.
Shows the number of incoming and outgoing unicast and broadcast packets for
each of the TV-PSM's networks.
Shows the number of packets initiated by the TV-PSM that are not in response to
a request from another device. The numbers in this table will also appear in the
appropriate columns in the Network Activity tab.
Error Rate Trend—Shows the total number of errors within the trend sampling
interval.
Packet Rate Trend—Shows the total number of packets transmitted and received
within the trend sampling interval.
35
Adjusting the TV-PSM driver properties
©2022 Carrier.
All rights reserved.
Advertisement
Table of Contents
