ITech IT6000C Series User Manual page 90

Mode
Step Count
Repeat
End State
Step Index
value
slope
Keep Time
– Sine: Sine wave
The fields included in the .csv template file are explained as follows:
Model
Firmware
Version
Serial Number
File Type
Waveform Type
Amp Unit
Offset Unit
Frequency Unit
Mode
Repeat
Copyright © Itech Electronic Co., Ltd.
Indicates the power supply working mode. The CV
priority is set to CV, and the CC priority is set to CC.
The total number of steps, up to 10 million points can
be edited.
Repeat times, the setting range is 1~65535.
Indicates the end state. Last (the voltage or current
maintained at the last step after the end) or Normal
(return to the normal mode before the List is executed
after the end).
The sequence number of the single step.
Voltage or current value for a single step.
Slope for a single step.
Pulse width for a single step.
Device model, keep the default settings without
modification.
Firmware version number, keep the default settings
without modification.
Device serial number, keep the default settings with-
out modification.
File type, keep the default settings without
modification.
Waveform type, keep the default settings without
modification.
Peak-to-peak unit, CV priority is set to V, CC priority
is set to A.
Offset value unit, CV priority is set to V, CC priority is
set to A.
Frequency unit, Hz.
Indicates the power supply working mode. The CV
priority is set to CV, and the CC priority is set to CC.
Repeat times, the setting range is 1~65535.
Power Supply Function
78