ITech IT6000C Series User Manual page 159

Select the battery simulation curve file for
Curve
testing.
Run
Open
Copyright © Itech Electronic Co., Ltd.
Power Supply Function
Simulates the internal
Inner
resistance of a cell
Resistance
battery.
Simulates the capacity
Capacity
of a cell battery.
Set the number of paral-
Parallel
lel connected batteries.
Set the number of bat-
Serial
teries in series.
Positive current limit val-
ue, which simulates the
I+
maximum discharge cur-
rent of the battery pack.
Negative current limit
value, which simulates
the maximum charge
I-
current of the battery
pack.
Set the save address of
Save To
the user-defined battery
Group
emulation file.
Run the currently selected battery sim-
ulation curve file.
Set the initial state of
charge (SOC) of the bat-
tery. 0~100% corre-
Initial Value
sponds to the voltage
range from no-load volt-
age to full-load voltage.
Open or select a battery simulation
curve file.
Select the battery simu-
USB lation curve file stored in
the USB flash disk.
147