Start-Up; Safety; General; Connecting The Gas Cylinder - Fronius TransTig 1750 Puls Operating Instructions Manual

Start-up

Safety

An electric shock can be fatal.
If the device is plugged into the mains during installation, there is a high risk of very serious
injury and damage.
► Only carry out work on the device if the mains switch is in the "O" position.
► Only carry out work on the charger when it has been disconnected from the mains sup-

General

Commissioning of the power source is described using a standard configuration for the
main TIG welding application.
The standard configuration consists of the following system components:
-
-
-
-
Connecting the
gas cylinder
If gas cylinders topple over, there is a risk of very serious injury and damage.
► Place gas cylinders on a solid, level surface in such a way that they remain stable
► Secure gas cylinders to prevent them from toppling over: fix the safety strap at the
► Never fix the safety strap around the neck of the cylinder
Follow the gas cylinder manufacturer's safety instructions.
1
2
3
4
5
When using a TIG welding torch with an integral gas connector:
6
7
When using a TIG welding torch with no integral gas connector:
6
40
WARNING!
ply.
Power source
TIG manual welding torch
Pressure regulator
Gas cylinder
WARNING!
same height as the top part of the cylinder
Secure the gas cylinder
Take the protective cap off the gas cylinder
Briefly open the gas cylinder valve to remove any dust or dirt
Check the seal on the pressure regulator
Screw the pressure regulator onto the gas cylinder and tighten it
Use the gas hose to connect the pressure regulator to the shielding gas connection on
the rear of the power source
Tighten the union nut on the gas hose
Connect the TIG welding torch gas hose to the pressure regulator