Mounting / Exchanging The Inner Liner For Hosepacks With A Fronius Welding Torch Connector; Safety; Tools Needed - Fronius PT-Drive Operating Instructions Manual

Mounting / exchanging the inner liner for hosepacks
with a Fronius welding torch connector

Safety

Tools needed

-
-
Dismount the
See the section headed "Dismount the torch hosepack"
torch hosepack
Remove the old Version without an extra wire-guidance nozzle
inner liner
Fig.11 Undoing the lock-nut
-
-
Version with an extra wire-guidance nozzle
Fig.13 Undoing the lock-nut
-
-
WARNING! Work that is not carried out correctly can cause serious injury and
damage. The actions described below may ONLY be carried out by skilled,
Fronius-trained personnel! Observe and follow all safety rules.
WARNING! Risk of injury from electric shock and from welding electrode emerg-
ing at speed from the torch. Before performing any of the actions described
below, unplug the power source from the mains and shift the mains switch to the
"O" position.
Fork spanner
span: 10 mm (.39 in.)
Knife
Loosen lock-nut at the welding torch connector end (19) and subsequently the
clamping piece (20) using a fork spanner with a span of 10 mm = .39 in.
Pull out the old inner liner (21)
(19)
Undo the lock-nut at the welding torch connector end (19) - completely with wire-
guidance nozzle (22) and subsequently loosen the clamping piece (20)
using a fork spanner with a span of 10 mm = .39 in.
Pull out the old inner liner (21)
- Pointed pliers
(19)
Fig.12 Undoing the clamping piece
(22)
Fig.14 Undoing the clamping piece
9
(20) (21)
(21) (20)