Installing The Standup Terminal; Safety; Screw The Mounting Bracket To The Standup Terminal - Fronius Virtual Welding 2.0 Operating Instructions Manual

Installing the Standup Terminal

Safety

Danger from electrical current.
This may result in serious injuries or death.
▶
▶
Danger from incorrect installation.
This can result in severe personal injury and damage to property.
▶
Screw the
mounting brack-
et to the Stan-
dUp Terminal.
Top of StandUp Terminal
1
WARNING!
Before starting work, switch off the device and disconnect it from the mains.
Secure the device to prevent it from being switched back on again.
WARNING!
Observe the information in section
(1) (1)
Screw the supplied mounting brackets onto the top of the StandUp Terminal
(1) as shown below, but do not tighten yet
- With 4 M8x16 mm screws and washers
- Do not tighten the 4 screws until the StandUp Terminal is at its final
setup location and the mounting brackets have been pushed up to the
wall
Setup regulations from page 31.
(1) (1)
33