Cleaning - Otto Bock Dynion 3R85 Instructions For Use Manual

8.2 Cleaning

CAUTION
Use of unsuitable cleaning agents or disinfectants
Impairment of functionality and damage due to incorrect cleaning agents or disinfectants
Only clean the product with the approved cleaning agents.
►
Only disinfect the product with the approved disinfectants.
►
Observe the instructions for cleaning and care.
►
Permissible cleaning agents and disinfectants
Requirements:
Free of solvents, chlorine and phosphates
INFORMATION
Clean the product if it gets dirty.
►
Observe the instructions for cleaning and drying in the section "Environmental conditions"
►
(see page 9).
Only use cleaning agents and disinfectants that do not affect the materials of the product.
►
Test the chosen agent for material compatibility in an inconspicuous location.
Do not spray the product directly with a pump spray or propellant spray cleaner and disin­
►
fectant.
Only apply cleaners and disinfectants using a soft, lint-free cloth.
►
Dry with a soft, lint-free cloth. Allow to air dry in order to remove residual moisture.
►
Observe the cleaning instructions for all prosthetic components.
►
► NOTICE! To properly remove particles of dirt and salt crystals, perform the following steps:
→ Activate cycling mode.
→ Immerse the prosthetic knee joint in clean, fresh water.
→ Move the prosthetic knee joint back and forth in the water (also perform flexion and exten­
sion several times) to rinse out particles of dirt and salt crystals.
→ Take the prosthetic knee joint out of the water and allow the remaining water to drain.
→ Dry the prosthetic knee joint with a lint-free cloth and allow it to air dry in order to remove
residual moisture.
→ Check the prosthetic knee joint for proper functioning (e.g. flexion and extension, switch­
ing threshold, cycling mode and lock).
→ After reaching the maximum period of use for salt water (days per year: 14 – hours per
day: 0.5), have the prosthetic knee joint checked by qualified personnel.
→ Deactivate cycling mode.
48