Preparing The Product For Use - Otto Bock Michelangelo Hand 8E500 Instructions For Use Manual

6 Preparing the product for use

6.1 Donning the prosthetic glove
INFORMATION
Do not use silicone spray when putting on the prosthetic glove. This impairs the secure fit of the
glove and can limit the functionality of the product (hand).
Observe the instructions for use provided for the prosthetic glove and the process for putting it
on and taking it off described in the same.
For daily use, the Michelangelo Hand must be worn with the AxonSkin prosthetic glove. The glove
protects the mechanism against environmental influences such as moisture, dirt and dust.
For information about the use (putting on and taking off) and care of the prosthetic glove, please
refer to the instructions for use included with the prosthetic glove.
6.2 Settings
Adjustments to the product can be made via Bluetooth data transmission using the 560X500=*
AxonSoft software. For this purpose, a wireless connection must be established between the
13E500 AxonMaster and the PC with the help of the 60X5 BionicLink PC.
For further information, see the instructions for use provided with the 13E500 AxonMaster and the
560X500=* AxonSoft software.
7 Use
7.1 Changing the Axon-Bus gripping component
Attaching the Axon-Bus gripping component to the socket
1) Slide the terminal device on to the socket (rotation anchored in the socket) until it locks in
place audibly.
2) Verify proper attachment by pulling on the terminal device.
Separating the Axon-Bus gripping component from the socket
7.2 Switching the product on and off
INFORMATION
Switching off the Axon-Bus prosthetic system during extended passive pauses (e.g. air or rail
travel, visit to a theatre or cinema, etc.) will make the battery last longer before requiring a
recharge. Only the entire Axon-Bus prosthetic system with all connected components can be
switched off. Individual Axon-Bus components cannot be switched off separately.
10
1) To switch off the Axon-Bus prosthetic system, press the charging
receptacle button and hold for more than one second.
2) Press both unlock buttons on the flexion wrist unit.
INFORMATION: For safety reasons the Axon-Bus gripping
component cannot be removed if only one unlock button is
pressed.
3) Separate the Axon-Bus gripping component from the socket.