Installation Inspection - WBM KOMATSU GD655-6 Manual

MSW102 SNOW WING
PARTS, SERVICE AND INSTALLATION
ASSEMBLY AND INSTALLATION

INSTALLATION INSPECTION

Installation Inspection
1. Check all bolts, all hose fittings and all connections for tightness.
2. Check that the position of the rear stop assembly will make contact with the
pushpole, while in the transport position. Ensure the DEF tank access door can be
fully opened and is not obstructed. If not already completed, fully weld the stop
assembly on the rear mount.
3. Check that the "do not articulate when snow wing is in the transport or stowed
position" warning decal is permanently affixed in the cab.
4. Check for proper clearances of components through full range of operation.
5. Install ladder on ladder spacer.
6. Re-install the work light. Use the WBM provided work light wiring harness extension to
reconnect the right side work light to the factory work light wiring harness. See photo
below.
Weldco-Beales Manufacturing
WBM
RIGHT SIDE LADDER
SPACER MOUNT
FACTORY WORK LIGHT
WIRING HARNESS
RIGHT SIDE
Page 34