Table of Contents
Advertisement
MSW102 SNOW WING
PARTS, SERVICE AND INSTALLATION
ASSEMBLY AND INSTALLATION
COMPONENT INSTALLATION
11. Install the snow wing moldboard on the snow wing front mount blade hinge with
the 2" hinge bolt, nut and washer. The bolt must be installed with the nut on the
blade side of the moldboard.
DO NOT OVERTIGHTEN THE NUT, the moldboard MUST be allowed to pivot. With the
nut properly tightened, install the cotter pin.
Once secured, position the moldboard at approximately 45 degrees to the
machine.
Weldco-Beales Manufacturing
BOLT, 2.00 X NC X 8.50
SLOTTED NUT, 2 - 4.5 UNC
FLAT WASHER, 2.00
COTTER PIN, 0.375 X 5.00
WBM
Page 19
Advertisement
Table of Contents
