WBM KOMATSU GD655-6 Manual page 16

MSW102 SNOW WING
PARTS, SERVICE AND INSTALLATION
ASSEMBLY AND INSTALLATION
COMPONENT INSTALLATION
7. Remove the reinforcement plate and blocks from the back of the rear mount plate
(tack welded for shipping).
PUSHPOLE STOP
8. Fully weld the spacer blocks to the Komatsu ripper mount. The top of the first block
needs to be 10 1/4 inches from the top of the ripper mount. The top of the second
block needs to be 15 9/16 inches from the top of the ripper mount.
9. Install the back plate of the rear mount onto the Komatsu ripper mount, 9 inches
from the top of the plate to the top of the ripper.
Weldco-Beales Manufacturing
REAR MOUNT
REMOVE THE REINFORCEMENT
PLATE FROM THE BACK OF THE
REAR MOUNT
REMOVE THE SPACER BLOCKS
FROM THE PLATE (TACK WELDED
FOR SHIPPING)
1/2
9
1/2
WBM
7018 ROD OR
EQUIVALENT TYPICAL
7018 ROD OR
EQUIVALENT TYPICAL
Page 16