WBM KOMATSU GD655-6 Manual page 13

MSW102 SNOW WING
PARTS, SERVICE AND INSTALLATION
ASSEMBLY AND INSTALLATION
COMPONENT INSTALLATION
Correctly sized lifting devices and rigging must be used for handling and moving components.
Failure to do so may result in injury or death.
5. To install the snow wing front lift-frame to the motor grader:
i. Align the snow wing front lift-frame with the main frame of the motor grader.
ii. With the lift-frame contacting the motor grader main frame, move the lift-frame
up and down the grader frame until the bottom of the lift-frame is 17-15/16
inches from the ground (see illustration below).
iii. Install one clamp plate and two shims on each side of the mount.
iv. Tighten the clamp plates, lift-frame and shims with ten HHCS 1.00-NC X 4.50 GR.8
bolts, twenty 1.00 flat washers and ten 1.00- NC nuts.
IMPORTANT: Check the clearance between the lift-frame and the grader circle. Adjust
the position of the lift-frame as required. Torque bolts to specifications.
17 15/16
Weldco-Beales Manufacturing
DANGER
!
HHCS 1.00-NC X 4.50 GR. 8
1.00 FLAT WASHER
CLAMP PLATE
SHIM
SHIM
LIFT-FRAME
FLAT WASHER
NUT
WBM
Page 13