Hydraulic Installation - WBM KOMATSU GD655-6 Manual

MSW102 SNOW WING
PARTS, SERVICE AND INSTALLATION
ASSEMBLY AND INSTALLATION

HYDRAULIC INSTALLATION

Hydraulic Installation
Additional hydraulic valves and controls may be required to operate the snow wing. If
the motor grader is not equipped with a sufficient number of hydraulic valve sections:
• Hydraulic valves can be installed below the operator's cab on the right side.
• Valve controls will need to be installed in the cab.
Please note pictures are for reference only, and actual installation may vary.
PUSHPOLE
EXTENSION
CYLINDER
(6 HOSES
TO VALVE)
MOLDBOARD
LIFT CYLINDER
(2 HOSES TO
VALVE)
Route the hoses so they will not pinch, overheat or become damaged. Check for possible pinch
points throughout the operating range of the snow wing. Install hose clamps where required.
Operating the snow wing with damaged hydraulic hoses may result in property damage, serious
injury or death.
Weldco-Beales Manufacturing
SNOW WING
CONTROL PANEL
WBM
HYDRAULIC
VALVE
WARNING
!
ELECTRICAL TO FACTORY FUSE BOX,
BOX PROTECT WIRING WITH
5 AMP FUSE
FLOW
CONTROL
VALVE
RELIEF
VALVE
FRONT MOUNT
LIFT CYLINDER
(4 HOSES AND
RELIEF VALVE
TO VALVE)
WBM
MACHINE'S
FACTORY
LOAD SENSE
LINE
MACHINE'S
FACTORY
PUMP LINE
(LEFT SIDE)
MACHINE'S
FACTORY
TANK LINE
(RIGHT SIDE)
Page 23