Settings; Prerequisites - Otto Bock Motus CV Instructions For Use Manual

Settings

2) Unfold the wheelchair:
→ Loosen the safety strap.
→ Press the wheelchair apart with your flat hands (see fig. 2; see fig. 3).
3) Pull up the flap of the back support upholstery and attach it to the seat upholstery with the hook-and-loop
fastener (see fig. 4).
4) For option "drive wheel with one-handed operation": Insert the telescoping rod (see instructions for use
(user)).
5) If necessary: Attach the leg supports. Fold the foot plate(s) down. With a single-panel foot plate, make sure
the support of the foot plate is locked into the receiver.
6) If necessary: Secure the seat cushion against sliding by pressing it onto the hook-and-loop fastener.
1
3
6 Settings

6.1 Prerequisites

WARNING
Making incorrect adjustments
Tipping over, falling or malposition of the user due to incorrect adjustments
► Adjustment and assembly work may be carried out only by qualified personnel.
► Only the adjustments described in these instructions for use may be carried out.
► Settings may only be changed within the allowable adjustment ranges; otherwise, the stability of the product
may be impaired (see this section and the "Technical data" section). If you have questions, contact the
manufacturer's service department (see inside back cover for addresses).
► Only conduct tests in the presence of an assistant.
► Unless expressly described, you may not change any settings with a person sitting in the product.
► Secure the user against falling out during all tests.
► Before testing setting changes with the user seated, firmly tighten all screw connections.
► Check for safe function before delivering the product.
8
2
4
Motus CV, Motus CS