Table of Contents
Advertisement
2
4
7 Settings and assembly instructions
7.1 Prerequisites
WARNING
Incorrect settings
Tipping over, falling or malposition of the user due to incorrect settings
► Adjustment and installation work may not be completed by the product user but only by instructed, qualified
personnel.
► Only the settings described in these instructions for use may be carried out.
► Settings may only be changed within the allowable adjustment ranges; otherwise, the stability of the product
may be impaired (see this chapter and the chapter "Appendices"). If you have questions, contact the manu
facturer's service (see back cover for addresses).
► Only conduct tests in the presence of an assistant.
► Unless expressly described, you may not change any settings with a person sitting in the product.
► Secure the user against falling out during all tests.
► Before testing setting changes with the user seated, firmly tighten all screw connections.
► Check for safe function before delivering the product.
CAUTION
Unsecured screw connections
Pinching, crushing, tipping over, falling of user due to assembly errors
► Always firmly re-tighten the mounting screws and nuts after changing settings. Observe the specified torques
in doing so.
► Any time you loosen a screw connection with thread lock, replace it with a new screw connection with thread
lock or secure the old screw connection with medium strength thread locker (e.g. Loctite 241).
► Always replace self-locking screws and nuts with new self-locking screws and nuts after disassembly.
Start B2
Settings and assembly instructions
3
5
13
Advertisement
Table of Contents
