Settings; Prerequisites - Otto Bock Avantgarde XXL 2 Instructions For Use Manual

Settings

CAUTION
Failure to verify readiness for use before putting into operation
Tipping, falling due to incorrect adjustment or installation
► Before you start using the wheelchair for the first time, check the chosen wheelchair settings with the support
of qualified personnel.
► After every assembly, check for proper mounting of the drive wheels. The quick-release axles must be
securely locked in the receiver bushings.
► Pay particular attention to the stability against tipping, free running of the drive wheels and correct function of
the wheel locks.
► Check the tyre pressure. The correct tyre pressure is printed on the sidewall. Ensure that the pressure is the
same in both tyres.
1) Attach the drive wheels to the quick-release axle mountings. The quick-release axles must not be removable
after releasing the push-button.
2) Loosen the safety strap by means of the push-button and unfold the wheelchair.
3) If necessary: Insert the leg supports into the retainer. Fold the foot plate(s) down. With a single-panel foot
plate, make sure the support of the foot plate is locked into the receiver.
4) Fit the seat cushion.
6 Settings

6.1 Prerequisites

WARNING
Making incorrect adjustments
Tipping over, falling or malposition of the user due to incorrect adjustments
► Adjustment and assembly work may be carried out only by qualified personnel.
► Only the adjustments described in these instructions for use may be carried out.
► Settings may only be changed within the allowable adjustment ranges; otherwise, the stability of the product
may be impaired (see this section and the "Technical data" section). If you have questions, contact the
manufacturer's service department (see inside back cover for addresses).
► Only conduct tests in the presence of an assistant.
► Unless expressly described, you may not change any settings with a person sitting in the product.
► Secure the user against falling out during all tests.
► Before testing setting changes with the user seated, firmly tighten all screw connections.
► Check for safe function before delivering the product.
CAUTION
Unsecured screw connections
Pinching, crushing, tipping over, falling of user due to assembly errors
► Always firmly re-tighten the mounting screws and nuts after changing settings. Observe the specified torques
in doing so.
► Any time you loosen a screw connection with thread lock, replace it with a new screw connection with thread
lock or secure the old screw connection with medium strength thread locker (e.g. Loctite 241).
► Always replace self-locking screws and nuts with new self-locking screws and nuts after disassembly.
Fine-tuning and adjustments should always be carried out in the presence of the user. The user should be sitting
upright in the wheelchair while making adjustments.
All parts of the product should be cleaned thoroughly before adjustments are made.
The tools required for adjustments and maintenance tasks as well as the torque values for screw connections are
listed in the section "Appendices" (see Page 27).
8 Avantgarde XXL 2