Instructions For Use (Qualified Personnel) - Otto Bock Kenevo Protector 4X840 Instructions For Use Manual

4.2 Structure of the safety instructions
CAUTION
The heading describes the source and/or the type of hazard
The introduction describes the consequences in case of failure to observe the safety instruc­
tions. Consequences are presented as follows if more than one consequence is possible:
> E.g.: Consequence 1 in case of failure to observe the hazard
> E.g.: Consequence 2 in case of failure to observe the hazard
This symbol identifies activities/actions that must be observed/carried out in order to avert
►
the hazard.
4.3 General safety instructions
CAUTION
Non-observance of safety instructions
Personal injury/damage to the product due to using the product in certain situations.
Observe the safety instructions and the stated precautions in this accompanying document.
►
CAUTION
Improper disassembly, assembly and handling of the product
> Injury due to pinching of body parts.
> Possible injury in case of parts with sharp edges.
Use increased caution during disassembly/assembly and handling of the product.
►
Instruct the patient in the proper disassembly, assembly and handling of the product.
►
NOTICE
Mechanical damage to the product
Change in or loss of functionality due to damage.
Use caution when working with the product.
►
If the product is damaged, check it for proper function and readiness for use.
►
Take any necessary measures (e.g. repair, replacement, inspection by the manufacturer's
►
customer service, etc.).
5 Scope of delivery
• 1 pc. Kenevo Protective Cover main unit
• 1 pc. 4P840=R lengthwise closure
• 1 pc. 4P860=U upper closure
• 1 pc. 4P8 Distal cap
• 1 pc. Instructions for use (qualified personnel)
• 1 pc. Instructions for use (user)
6 Preparing the product for use
6.1 Required tools
• 718H5 Deburring knife
• 743B2 Tape measure
• 627B6=15 Crepe adhesive tape
• 636K13 adhesive (Loctite 241)
• Vibrating/band saw
• 710D20 Torque wrench
11