Instructions For Use (Qualified Personnel) - Otto Bock AxonRotation 9S503 Instructions For Use Manual

CAUTION
Proximity to sources of strong magnetic or electrical interference (e.g. theft prevention
systems, metal detectors)
Injury due to unexpected behaviour of the product caused by interference with internal data
communication.
Avoid remaining in the vicinity of visible or concealed theft prevention systems at the
►
entrance/exit of stores, metal detectors/body scanners for persons (e.g. in airports) or other
sources of strong magnetic and electrical interference (e.g. high-voltage lines, transmitters,
transformer stations, computer tomographs, magnetic resonance tomographs, etc.).
When walking through theft prevention systems, body scanners or metal detectors, watch
►
for unexpected behaviour of the product.
NOTICE
Improper product care
Damage to the product due to the use of incorrect cleaning agents.
Clean the product and the contacts with a damp cloth and mild soap only.
►
5 Scope of delivery
• 9S503 AxonRotation (active rotation unit)
• 4 pcs. M3 x 8 Torx screws
• 1 pc. Torx offset screwdriver
• 1 pc. Instructions for use (qualified personnel)
6 Preparing the product for use
1) Use silicone grease to seal the plug connection.
2) Connect the product with the connecting cable.
3) Position the product so that the arrow mark points in the direction of the ulna (outside of the
arm). (see fig. 1)
4) Screw the product to the lamination ring. (see fig. 1)
INFORMATION: Tighten the screws hand-tight and do not use a thread lock such as
Loctite.
7 Maintenance
Performing regular maintenance (service inspections) every 24 months is recommended to pre­
vent injuries and maintain the quality of the product.
In general, all products are subject to compliance with the maintenance intervals during the war­
ranty period. This is the only way to maintain full warranty cover.
Additional services such as repairs may be provided in the course of maintenance. These addi­
tional services may be provided free of charge or can be billable according to an advance cost
estimate, depending on the extent and validity of the warranty.
The following components must always be sent in for maintenance and repairs:
The product, battery charger and power supply. The shipping container for the loaner unit you
receive must be reused for sending back the components requiring inspection.
8 Legal information
8.1 Liability
The manufacturer will only assume liability if the product is used in accordance with the descrip­
tions and instructions provided in this document. The manufacturer will not assume liability for
10