Instructions For Use (Qualified Personnel) - Otto Bock AxonRotation Adapter 9S501 Instructions For Use Manual

Warning regarding possible technical damage.
NOTICE
4.2 Structure of the safety instructions
CAUTION
The heading describes the source and/or the type of hazard
The introduction describes the consequences in case of failure to observe the safety instruc­
tions. Consequences are presented as follows if more than one consequence is possible:
> E.g.: Consequence 1 in case of failure to observe the hazard
> E.g.: Consequence 2 in case of failure to observe the hazard
This symbol identifies activities/actions that must be observed/carried out in order to avert
►
the hazard.
4.3 General safety instructions
CAUTION
Non-observance of safety instructions
Personal injury/damage to the product due to using the product in certain situations.
Observe the safety instructions and the stated precautions in this accompanying document.
►
CAUTION
Independent manipulation of the product
Injury due to malfunction and resulting unexpected prosthesis actions.
Manipulations to the product other than the tasks described in these instructions for use are
►
not permitted.
The product and any damaged components may only be opened and repaired by authorised,
►
qualified Ottobock personnel.
NOTICE
Improper product care
Damage to the product due to the use of incorrect cleaning agents.
Clean the product and the contacts with a damp cloth and mild soap only.
►
5 Scope of delivery
• 1 pc. 9S501 AxonRotation Adapter (passive rotation unit)
• 4 pcs. M3 x 8 Torx screws
• 1 pc. Torx offset screwdriver
• 1 pc. Instructions for use (qualified personnel)
6 Preparing the product for use
A prosthetic socket with a lamination ring laminated into it has to be fabricated prior to assembly.
Consult the technical information for the information required to fabricate the socket.
1) Connect the plug socket and the plug (see fig. 1).
2) Set the product's oval plate onto the laminated lamination ring (see fig. 2).
3) Screw the product's oval plate to the lamination ring (see fig. 3).
INFORMATION: Hand-tighten the screws; do not use thread lock such as Loctite.
7 Handling
The Axon-Bus flexion components, such as the 9S500=* AxonFlexion adapter, can be separated
from the product by operating the unlock mechanism. The product remains on the prosthetic
9