Crutch Holder With Hook-And-Loop Fastening Strap; Headrest - Otto Bock Start M4 XXL Instructions For Use Manual

Use
Using the transport wheels
> Prior to use, verify whether the transport wheels have been set to the same height.
1) Remove the drive wheels.
Whenever possible, this should be done when the user is not sitting in the wheelchair. If the user is sitting in
the wheelchair, proceed as follows:
2) The first attendant holds the wheelchair in a stable position so that the drive wheels are relieved in turn.
3) The second attendant carefully removes the first and second drive wheel one after the other.
→ The wheelchair can now be pushed on the transport wheels.
58

7.15 Crutch holder with hook-and-loop fastening strap

The crutch holder with hook-and-loop fastening strap allows crutches to be attached to the wheelchair.
59

7.16 Headrest

Head/neckrests or headrests make it possible to support the head in case of various severe disability indications.
The head/neckrests or headrests consist of polyurethane foam and can be cleaned with mild soap and water.
The option is installed on the product by qualified personnel if needed and adapted to the requirements of the user.
The head support can be removed from the wheelchair for transportation.
Removing the head support
1) Release the clamping lever (see fig. 60, item 1).
2) Pull out the adjustment tube with the head support (see fig. 60, item 2).
Attaching the head support
1) Insert the adjustment tube with the head support into the clamp fitting to the stop (see fig. 60, item 2/3).
2) Tighten the clamping lever (see fig. 60, item 1).
34 Start M4 XXL, Start M6 Junior