40
42
6.5.2 Adjusting the back support angle
WARNING
Missing anti-tipper
Tipping over, falling of the user due to missing safety devices
► If the back is tilted far to the rear and in the case of a short wheelbase, 2 anti-tippers (one on each side) must
be mounted and in a functional position; in the case of a long wheelbase, at least one anti-tipper must be
mounted and in a functional position.
► Check that the anti-tipper is securely attached.
When using a back support with angle adjustment, the back support angle can be adjusted from +9° to -15° in 6°
steps to meet the needs of the user.
When using the back support with angle adjustment in combination with desk side panels, the back support angle
can only be adjusted from +3° to -9°.
1) Loosen the mounting screw (Allen head screw).
NOTICE! Ensure that the mounting screw is loosened enough to avoid damage to the ratchet mechan
ism.
2) Carry out the adjustment in the same way on both sides.
3) Re-tighten the mounting screw.
Avantgarde 4
1
41
43
Settings
21