Arm Supports/Hand Supports - Otto Bock Start M2S Instructions For Use Manual

Use

7.8 Arm supports/hand supports

As alternatives to the standard arm supports, various types of modular forearm supports and hand supports may be
installed on the wheelchair.
These are mounted either on the side panel or on a swivel unit.
28
Swivel unit for forearm supports
INFORMATION
Also observe the information in the separate instructions for use for this option.
INFORMATION
After adjusting the swivel unit, please always make sure that the lock pins have safely snapped in place.
The swivel unit allows the support angle and the rotation setting of an arm support to be adjusted individually.
Furthermore, the swivel unit is required for using a modular forearm support.
Adjusting the support angle
1) Pull the release button outwards (see fig. 29, item 1).
2) Lift up the arm support at the front end and adjust it to the desired angle (see fig. 29, item 2).
3) Let go of the release button. The arm support will be secured in its position.
Adjusting the rotation setting in 15° increments
1) Pull the release button downwards (see fig. 30, item 1).
2) Move the arm support to the desired rotation setting.
3) Let go of the release button. The arm support will be secured in its position.
Continuously adjusting the rotation setting
1) Pull the release button downwards (see fig. 30, item 1).
2) Turn the release button 90°. The arm support can be rotated freely in this position.
3) Move the arm support to the desired rotation setting.
4) Let go of the release button. The arm support will be secured in its position.
Adjusting the depth of the arm support
1) Loosen the Allen head screws under the arm support (see fig. 30, item 2).
2) Slide the arm support to the desired depth.
3) Re-tighten the Allen head screws under the arm support (see fig. 30, item 2).
22 Start M2S, Start M2