Otto Bock Start M2S Instructions For Use Manual page 16

Use
2) Swing the leg support into the direction of travel until it engages.
3) Fold the foot plate down.
6
Removing the leg support – elevating leg support/amputation leg support
1) Activate the release lever (see fig. 8/see fig. 9, item 1).
2) Pull the leg support up and off (see fig. 8/see fig. 9, item 2).
Attaching the leg support – elevating leg support/amputation leg support
1) Insert the leg support into the leg support retainer from above (see fig. 8/see fig. 9, item 2).
2) Push the leg support down until it engages.
8
Adjusting the angle of the elevating leg support/amputation leg support
1) Hold the leg support and turn the release lever upwards to the stop (see fig. 10/see fig. 11, item 1).
2) Set the angle (see fig. 10/see fig. 11, item 2).
3) Let go of the release lever. The leg support will automatically snap into place in the next free position.
10
16
7
9
11
Start M2S, Start M2