Seat Cushion; Backrest - Otto Bock Start M2S Instructions For Use Manual

17

7.5 Seat cushion

If present: The seat cushion can be removed from the wheelchair for cleaning.
1) Lay the seat cushion onto the seat upholstery and secure it against sliding by pressing it onto the hook-and-
loop fastener (see fig. 19).
2) To remove, detach the seat cushion from the hook-and-loop fastener on the upholstery.
19

7.6 Backrest

WARNING
Incorrect use of back support angle adjustment
Falling, tipping over due to operation without anti-tipper
► Note that adjusting the back support angle shifts the centre of gravity. Only use the back support angle
adjustment with the anti-tipper activated.
► Drive in street traffic only with a vertical back support.
The product can be equipped with a fixed or optionally an angle-adjustable backrest.
"Back support angle adjustment 30°" option
With this option, the back support angle is continuously adjustable from 90° to 120° in 10° increments (see fig. 20)
and the back support can be laid down onto the seat bottom.
1) Pull the cable of the back support release mechanism until the angle adjustment is released by the locking pins
(see fig. 21).
2) Move the back support to the desired position.
3) Release the cable. Ensure that the locking pins securely engage on both sides.
Start M2S, Start M2
18
Use
19