Adjusting The Leg Supports; Adjusting The Depth Of The Leg Supports; Adjusting The Depth Of The Foot Plate - Otto Bock Start Multi Instructions For Use Manual

26

7.7 Adjusting the leg supports

CAUTION
Improper adjustment of the legrests/footplates
Tipping over, falling due to user error
► After changing the legrest/footplate settings, verify that the legrests/footplates do not collide with the caster
wheels at any of the seat tilt settings (seat angle adjustment).
► The distance between the legrest/footplate and the caster wheel must be at least 25 mm.
The distance between the footplates and the sitting surface influences sitting stability. The height adjustment acts
on the pelvis and ischial bones.

7.7.1 Adjusting the depth of the leg supports

1) Remove the leg supports (see page 36).
2) Remove the hexagon socket screws on both sides between the leg support holder and the seat bar (see
fig. 28, item 1).
3) Slide the leg support holders to the desired depth (see fig. 28, item 2). Ensure that the depth setting is the
same.
4) Tighten the hexagon socket screws to 6 Nm.
5) Install the leg supports.
28

7.7.2 Adjusting the depth of the foot plate

1) Loosen the hexagon socket screws on the foot plate (see fig. 29, item 1).
2) Slide the foot plate to the desired depth.
3) Tighten the hexagon socket screws to 6 Nm.
Start Multi
Adjustments by qualified personnel
27
23