Setting Protocol Configuration Options For Radius (Juniper) - Cisco Servers User Manual

Chapter 3 Setting Up the Cisco Secure ACS HTML Interface
Step 3
Step 4

Setting Protocol Configuration Options for RADIUS (Juniper)

Note
Step 1
Step 2
78-13751-01, Version. 3.0
Select the check box for either User or Group, or both, for each RADIUS (Nortel)
service you want to appear as a configurable option on the User Setup or Group
Setup page.
Note Each attribute selected must be supported by the Nortel RADIUS
VSA.
Click Submit at the bottom of the page.
This procedure enables you to hide or display RADIUS (Juniper) attributes for
configuration from other portions of the Cisco Secure ACS HTML interface.
The RADIUS (Juniper) page lists all the attributes available for Juniper RADIUS.
If the Per-user TACACS+/RADIUS Attributes check box on the Advanced
Options page of Interface Configuration is selected, a User check box appears
alongside the Group check box for each attribute.
To set protocol configuration options for RADIUS (Juniper) attributes, follow
these steps:
Click Interface Configuration.
Click RADIUS (Juniper).
Result: The RADIUS (Juniper) edit page appears.
Cisco Secure ACS 3.0 for Windows 2000/NT Servers User Guide
Protocol Configuration Options for RADIUS
3-19