Cisco Servers User Manual page 146

Network Access Restrictions
Adding a Shared Network Access Restriction
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Note
Cisco Secure ACS 3.0 for Windows 2000/NT Servers User Guide
5-8
To add a shared NAR, follow these steps:
In the navigation bar, click Shared Profile Components.
Result: The Shared Profile Components page appears.
Click Network Access Restrictions.
Click Add.
Result: The Network Access Restriction page appears.
In the Name box, type a name for the new shared NAR.
The name can contain up to 32 characters. Leading and trailing spaces
Note
are not allowed. Names cannot contain the following four special
characters: [ ] , /
In the Description box, type a description of the new shared NAR.
To permit or deny access based on IP addressing, follow these steps:
This step is performed for IP-based restrictions where an IP connection exists.
For other restriction types, see the
section on page 5-6.
Select the Define IP-based access descriptions check box.
a.
b. To specify whether you are listing addresses that are permitted or denied,
from the Table Defines list, select the applicable value.
Chapter 5 Setting Up and Managing Shared Profile Components
"About Network Access Restrictions"
78-13751-01, Version 3.0