Table of Contents
Advertisement
Chapter 6
Setting Up and Managing User Groups
Configuring Microsoft RADIUS Settings for a User Group
Note
Step 1
Step 2
Step 3
Step 4
78-13751-01, Version 3.0
Microsoft RADIUS provides VSAs supporting MPPE, which is an encryption
technology developed by Microsoft to encrypt PPP links. These PPP connections
can be via a dial-in line, or over a VPN tunnel. The Microsoft RADIUS attribute
configurations appear only when both the following are true:
•
A network device has been configured in Network Configuration that uses a
RADIUS protocol that supports the Microsoft RADIUS VSA.
•
Group-level Microsoft RADIUS attributes have been enabled on the RADIUS
(Microsoft) page of the Interface Configuration section.
The following Cisco Secure ACS RADIUS protocols support the Microsoft
RADIUS VSA:
Cisco IOS/PIX
•
•
Cisco VPN 3000
Ascend
•
Microsoft RADIUS represents only the Microsoft VSA. You must configure both
the IETF RADIUS and Microsoft RADIUS attributes.
To hide or display Microsoft RADIUS attributes, see the
Configuration Options for RADIUS (Microsoft)" section on page
To configure and enable Microsoft RADIUS attributes to be applied as an
authorization for each user in the current group, follow these steps:
Confirm that your IETF RADIUS attributes are configured properly.
For more information about setting IETF RADIUS attributes, see the
"Configuring IETF RADIUS Settings for a User Group" section on page
In the navigation bar, click Group Setup.
Result: The Group Setup Select page opens.
From the Group list, select a group, and then click Edit Settings.
Result: The Group Settings page displays the name of the group at its top.
From the Jump To list at the top of the page, choose RADIUS (Microsoft).
Cisco Secure ACS 3.0 for Windows 2000/NT Servers User Guide
Configuration-specific User Group Settings
"Setting Protocol
3-17.
6-34.
6-41
Advertisement
Table of Contents
Troubleshooting
