Setting Protocol Configuration Options For Radius (Cisco Bbsm) - Cisco Servers User Manual

Protocol Configuration Options for RADIUS
Step 3
Step 4

Setting Protocol Configuration Options for RADIUS (Cisco BBSM)

Note
Step 1
Step 2
Step 3
Step 4
Cisco Secure ACS 3.0 for Windows 2000/NT Servers User Guide
3-20
Select the check box for either User or Group, or both, for each RADIUS
(Juniper) service you want to appear as a configurable option on the User Setup
or Group Setup page.
Note Each attribute selected must be supported by the Juniper RADIUS
VSA.
Click Submit at the bottom of the page.
This procedure enables you to hide or display the RADIUS (Cisco BBSM)
attribute for configuration from other portions of the Cisco Secure ACS HTML
interface.
The RADIUS (Cisco BBSM) page lists the attribute available for Building
Broadband Service Manger (BBSM) RADIUS.
If the Per-user TACACS+/RADIUS Attributes check box on the Advanced
Options page of Interface Configuration is selected, a User check box appears
alongside the Group check box for each attribute.
To set protocol configuration options for RADIUS (Cisco BBSM) attributes,
follow these steps:
Click Interface Configuration.
Click RADIUS (Cisco BBSM).
Result: The RADIUS (Cisco BBSM) edit page appears.
Select the check box for either User or Group, or both, for the service you want
to appear as a configurable option on the User Setup or Group Setup page.
Click Submit at the bottom of the page.
Chapter 3 Setting Up the Cisco Secure ACS HTML Interface
78-13751-01, Version. 3.0