Setting Nortel Radius Parameters For A User - Cisco Servers User Manual

Chapter 7 Setting Up and Managing User Accounts
Step 2
Step 3
Step 4

Setting Nortel RADIUS Parameters for a User

78-13751-01, Version 3.0
Before configuring Cisco IOS RADIUS attributes, be sure your IETF RADIUS
attributes are configured properly. For more information about setting IETF
RADIUS attributes, see the
section on page 7-37.
In the Microsoft RADIUS Attributes table, to specify the attributes that should be
authorized for the user, follow these steps:
a. Select the check box next to the particular attribute.
Further define the authorization for that attribute in the box next to it.
b.
Continue to select and define attributes, as applicable.
c.
For more information about attributes, see
Attributes," or your AAA client documentation.
The MS-CHAP-MPPE-Keys attribute value is generated by
Note
Cisco Secure ACS; there is no value to set in the HTML interface.
Do one of the following:
If you are finished configuring the user account options, click Submit to
a.
record the options.
To continue to specify the user account options, perform other procedures in
b.
this chapter, as applicable.
The Nortel RADIUS parameters appear only if all the following are true:
A AAA client has been configured to use RADIUS (Nortel) in Network
•
Configuration.
The Per-user TACACS+/RADIUS Attributes check box is selected under
•
Advanced Options in the Interface Configuration section.
User-level RADIUS (Nortel) attributes you intend to apply have been enabled
•
under RADIUS (Nortel) in the Interface Configuration section.
Cisco Secure ACS 3.0 for Windows 2000/NT Servers User Guide
Advanced User Authentication Settings
"Setting IETF RADIUS Parameters for a User"
Appendix D, "RADIUS
7-45