Table of Contents
Advertisement
Advanced User Authentication Settings
Step 3
Step 4
Setting Cisco VPN 5000 Concentrator RADIUS Parameters for a User
Note
Cisco Secure ACS 3.0 for Windows 2000/NT Servers User Guide
7-42
In the Cisco VPN 3000 Concentrator Attribute table, to specify the attributes that
should be authorized for the user, follow these steps:
Select the check box next to the particular attribute.
a.
Further define the authorization for that attribute in the box next to it.
b.
Continue to select and define attributes, as applicable.
c.
For more information about attributes, see
Attributes,"
or your AAA client documentation.
Do one of the following:
If you are finished configuring the user account options, click Submit to
a.
record the options.
b.
To continue to specify the user account options, perform other procedures in
this chapter, as applicable.
The Cisco VPN 5000 Concentrator RADIUS attribute configurations display only
if all the following are true:
•
A AAA client has been configured to use RADIUS (Cisco VPN 5000) in
Network Configuration.
•
The Per-user TACACS+/RADIUS Attributes check box is selected under
Advanced Options in the Interface Configuration section.
•
User-level RADIUS (Cisco VPN 5000) attributes you intend to employ have
been enabled under RADIUS (Cisco VPN 5000) in the Interface
Configuration section.
Cisco VPN 5000 Concentrator RADIUS represents only the Cisco VPN 5000
Concentrator VSA. You must configure both the IETF RADIUS and Cisco VPN
5000 Concentrator RADIUS attributes.
To hide or display Cisco VPN 5000 Concentrator RADIUS attributes, see the
"Setting Protocol Configuration Options for RADIUS (Cisco VPN 5000)"
section on page
3-16.
Chapter 7
Setting Up and Managing User Accounts
Appendix D, "RADIUS
78-13751-01, Version 3.0
Advertisement
Table of Contents
Troubleshooting
