Table of Contents
Advertisement
Chapter 7
Setting Up and Managing User Accounts
Setting IETF RADIUS Parameters for a User
Note
Note
Note
78-13751-01, Version 3.0
•
Setting Cisco VPN 5000 Concentrator RADIUS Parameters for a User,
page 7-42
Setting Microsoft RADIUS Parameters for a User, page 7-44
•
Setting Nortel RADIUS Parameters for a User, page 7-45
•
Setting Juniper RADIUS Parameters for a User, page 7-47
•
•
Setting BBSM RADIUS Parameters for a User, page 7-48
To configure custom VSAs, see the
User" section on page
RADIUS attributes are sent as a profile for the user from Cisco Secure ACS to the
requesting AAA client.
These parameters display only if all the following are true:
A AAA client has been configured to use one of the RADIUS protocols in
•
Network Configuration.
•
The Per-user TACACS+/RADIUS Attributes check box is selected under
Advanced Options in the Interface Configuration section.
•
User-level IETF RADIUS attributes have been enabled under RADIUS
(IETF) in the Interface Configuration section.
To display or hide any of these attributes in the HTML interface, see the
"Protocol Configuration Options for RADIUS" section on page
For a list and explanation of RADIUS attributes, see
Attributes,"
or the documentation for your particular network device using
RADIUS.
RADIUS (Cisco Aironet) is not an option since there are no Cisco
Aironet-specific VSAs. The length of user session timeouts is controlled by
IETF RADIUS attribute 27, Session-Timeout.
Cisco Secure ACS 3.0 for Windows 2000/NT Servers User Guide
"Setting Custom RADIUS Attributes for a
7-49.
Advanced User Authentication Settings
3-10.
Appendix D, "RADIUS
7-37
Advertisement
Table of Contents
Troubleshooting
