Tacacs+ Settings (User); Configuring Tacacs+ Settings For A User - Cisco Servers User Manual

Advanced User Authentication Settings

TACACS+ Settings (User)

Configuring TACACS+ Settings for a User

Cisco Secure ACS 3.0 for Windows 2000/NT Servers User Guide
7-24
The TACACS+ Settings section permits you to enable and configure the
service/protocol parameters to be applied for the authorization of a user. This
section contains the following procedures:
Configuring TACACS+ Settings for a User, page 7-24
•
Configuring a Shell Command Authorization Set for a User, page 7-26
•
• Configuring a PIX Command Authorization Set for a User, page 7-29
Configuring the Unknown Service Setting for a User, page 7-31
•
You can use this procedure to configure TACACS+ settings at the user level for
the following service/protocols:
• PPP IP
PPP IPX
•
• PPP Multilink
PPP Apple Talk
•
PPP VPDN
•
• PPP LCP
ARAP
•
• Shell (exec)
• PIX Shell (pixShell)
SLIP
•
You can also enable any new TACACS+ services that you may have configured.
Because having all service/protocol settings display within the User Setup section
would be cumbersome, you choose what settings to hide or display at the user
level when you perform configure the interface. For more information about
setting up new or existing TACACS+ services in the Cisco Secure ACS HTML
interface, see the "Protocol Configuration Options for TACACS+" section on
page 3-7.
Chapter 7 Setting Up and Managing User Accounts
78-13751-01, Version 3.0