Cisco Servers User Manual page 148

Network Access Restrictions
Tip
Step 8
Editing a Shared Network Access Restriction
Step 1
Step 2
Step 3
Cisco Secure ACS 3.0 for Windows 2000/NT Servers User Guide
5-10
d. To specify the information that this NAR should filter on, fill in the following
boxes, as applicable:
You can type an asterisk (*) as a wild card to specify "all" either as a value or
within a range.
• Port—Type the number of the port to filter on.
CLI—Type the CLI number to filter on. You can also use this box to
•
restrict access based on values other than CLIs, such as an IP address or
MAC address; for information, see the
Restrictions" section on page
DNIS—Type the number being dialed into to filter on.
•
e. Click enter.
Result: The information specifying the NAR line item appears in the table.
To enter additional non-IP based NAR line items, repeat Steps C through E.
f.
When you are finished defining the shared NAR, click Submit.
Result: Cisco Secure ACS saves the named shared NAR and lists it in the Network
Access Restriction Sets table.
To edit a shared network access restriction, follow these steps:
In the navigation bar, click Shared Profile Components.
Result: The Shared Profile Components page appears.
Click Network Access Restrictions.
Result: The Network Access Restrictions table appears.
In the Name column, click the shared NAR you want to edit.
Result: The Network Access Restriction page appears with information displayed
for the selected filter.
Chapter 5 Setting Up and Managing Shared Profile Components
"About Network Access
5-6.
78-13751-01, Version 3.0