Advertisement
4. SETUP MENU
Setup menu is as follows.
Main
Item
Initial Value
System Time
00:00:00
System Date
01/01/2002
Legacy Diskette A:
Enabled
Primary Master
Auto
Serial port A
Enabled
Serial port B
Enabled
Parallel port
Enabled
Mode
Bi-Directional
Boot
Item
Initial Value
Boot Device Priority
FD/IDE Devices
Exit
Item
Exit Save Changes
Exit Discard Changes
Load SETUP Defaults
Discard Changes
Save Changes
Set System Time for battery backup RTC.
Setting format is (HH:MM:SS).
If RTC data is undefined, clock is initialized to 00:00:00
Set System Date.
Set System Date for battery backup RTC.
Setting format is (MM/DD/YYYY).
If RTC data is undefined, clock is initialized to 2002-01-01.
Set enable/disable on internal FDD.
Set internal HDD type.
By setting to Auto, default size of HDD is automatically detected at BIOS boot up.
Set enable/disable on COM1.
Set enable/disable on COM2.
Set enable/disable on LPT1.
Set LPT1 Mode.
Can configurable [Output only], [Bi-Directional],[EPP],[ECP].
Use [Bi-Directional] until announced by RETAILING SYSTEMS DEVELOPMENT DEPARTMENT.
Set boot device priority.
Don't change this setting until announced by RETAILING SYSTEMS EVELOPMENT DEPARTMENT.
System reset after save SETUP value to CMOS RAM.
Discard all changes and System reset.
Load SETUP defaults to CMOS RAM.
Discard all changes.
Save SETUP value to CMOS RAM.
UP-5900VS BIOS SETUP UTILITY
6 – 2
Description & Note
Description & Note
Description
Advertisement
Chapters
