Table of Contents
Advertisement
Specification
Suitability
Data plate
Convection fan
Gas connection
Ignition
Installation considerations
Flue
Noise level
Electrical
Safety devices
Temperature control
Weight
* Coaxial:
One flue, the exhaust flue is nested inside the air intake flue—these are rigid flues
A direct vent (room sealed) freestanding gas fireplace with
glass front and convection fan, pushing warm air from the top
of the appliance. Operated using a simple IR remote to control
flame height and fan speed, or by the Rinnai Wi-Fi app (optional
accessory) that allows full thermostatic control, as well as other
features such as timers.
Input:
14-30 MJ/h
Output:
3-6.6 kW*
Efficiency:
80%
Heating area: 65-112 m
Gas type:
NG or ULPG
* Will vary according to gas type and flue configuration
** Will vary depending on location in NZ
Suitable for freestanding installations in open plan areas and living rooms.
As a room sealed appliance it can also be installed in larger bedrooms if
this meets the 6.10.6.1 requirements of AS/NZS 5601.1.
Lower RHS of the base panel (in front of the gas control)
120 V AC 50 Hz 2-speed centrifugal blower
Brass ½ " BSPT male fitting. The gas supply terminates inside the unit—
lower RHS of the appliance.
230-240 V AC 50 Hz high voltage electronic spark generation
Room size, smaller rooms will heat up quickly, and due to the heat of the
appliance, the fire will turn to a low setting once the set temperature has
been reached.
Direct vent coaxial* flue. Draws air for combustion from the outside and
expels combusted gases to the outside. Appliance must be installed with a
Rinnai flue system.
•
inner Ø 100 mm
•
outer Ø 170 mm
37-45 dB(A)
A 1.5 m power cord with a thee pin plug is supplied. The power cord passes
through a slot in the back left hand corner of the appliance.
High - 50 W
Standby - <3 W
Flame failure sensing system, pressure relief, overheat safety switch, air
temperature sensor, thermal fuse, overcurrent fuse, and spark detection.
Operated by using the basic IR remote to control flame height and fan
speed, or for more features, such as timers and thermostatic control, using
Rinnai's Wi-Fi fireplace controller app—Wi-Fi module purchased as an
optional accessory.
Novo Cube = 75 kg
Novo Freestander cabinet base = 14 kg
Novo Freestander plinth base = 10 kg
**
2
Coaxial
Novo freestanding installation guide: 13992-A 01-22 | 5
Advertisement
Table of Contents
