Neo Specification - Rinnai Neo Series Installation Manual

Neo Specification
Natural draft burning log effect inbuilt gas fire with glass front and convection fan. Operated by
simple infra-red remote or by the Rinnai Wi-Fi app that allows full thermostatic control, as well as
other features such as timers. Different frame options available.
Specification summary
Input = 14-30 MJ/h*
Output = 2.98-6.94 kW*
Efficiency = 80%
Heating area = 69-107 m
Gas type = NG or ULPG
* Will vary according to gas type and flue configuration
** Will vary depending on geographical location in NZ
Suitability
- Inbuilt masonry
- Inbuilt mock chimney
- Freestanding
The Neo is not suitable for areas where
painting is taking place, or in places such as
hairdressing salons, where there may be fluff
and dust, and where aerosols are used.
Installation considerations
The Neo draws air for combustion from the
room. Adequate ventilation must be calculated
and provided by the gasfitter as per
AS/NZS 5601.1.
Burn media
Driftwood log set comes as standard.
Convection fan
Fan forced 2-speed convection fan (low and
high). Heat is distributed from the top of the
appliance.
Data plate
Inside appliance on the front left hand side.
Gas connection
½ " BSPT (flexi). The gas supply terminates
inside the heater at the lower front right hand
side of the appliance.
Ignition
Continuous spark electronic ignition.
Noise level: 37-45 dB(A)
2 **
Flue (masonry)
The Neo must be installed with a Rinnai
flexiliner flue (Ø 100 mm).
Flue (mock chimney and freestanding)
Appliance must be installed with a Rinnai flue
system. Inner 100 mm, outer 150 mm.
Power consumption and electrical supply
High = 50 W
Standby = < 3 W
Comes with a 1.5 m power cord and 3-pin plug.
The standard electrical connection is to the
rear left of the appliance, but can pass through
the left or right by removing the knockout tab
from the bottom edge of the front panel.
Safety devices
Overheat switch, electrical fuse, and flame
failure sensing system.
Temperature control
Operated by using the basic infra-red remote*, or
for more features, such as timers and thermostatic
control, using Rinnai's Wi-Fi fireplace controller
app.
* Temperature sensor is located in the bottom of the remote
Weights
Engine 60 kg
Freestanding kits 20-21 kg
Neo RIB2312 installation guide: 12148-D 04-19 | 5