Table of Contents
Advertisement
Specification
Suitability
Data plate
Convection fan
Gas connection
Ignition
Installation considerations
Flue masonry
Flue mock chimney
Noise level
Electrical
Safety devices
Temperature control
Weight
* Colinear:
Uses TWO separate flexible aluminium chimney liners as the flue system
** Coaxial:
One flue, the exhaust flue is nested inside the air intake flue—these are rigid flues
6 | Novo DV inbuilt installation guide: 13748-C 03-22
A direct vent (room sealed) inbuilt gas fireplace with glass
front and convection fan, pushing warm air from the top of the
appliance. Operated using a simple IR remote to control flame
height and fan speed, or by the Rinnai Wi-Fi app (optional
accessory) that allows full thermostatic control, as well as other
features such as timers.
Input:
14-30 MJ/h
Output:
3-6.6 kW*
Efficiency:
80%
Heating area: 65-112 m
Gas type:
NG or ULPG
* Will vary according to gas type and flue configuration
** Will vary depending on location in NZ
Suitable for masonry installations and installations into a mock chimney
in open plan areas and living rooms. As a room sealed appliance it can
also be installed in larger bedrooms as long as this meets the 6.10.6.1
requirements of AS/NZS 5601.1.
Lower RHS of the base panel (in front of the gas control)
120 V AC 50 Hz 2-speed centrifugal blower
Brass ½ " BSPT male fitting. The gas supply terminates inside the unit—
lower RHS of the appliance.
230-240 V AC 50 Hz high voltage electronic spark generation
Room size, smaller rooms will heat up quickly, and due to the heat of the
appliance, the fire will turn to a low setting once the set temperature has
been reached.
Colinear* direct vent flexi flue, air intake Ø75 mm, exhaust Ø100 mm
Coaxial** direct vent flue, inner Ø100 mm, outer Ø170 mm.
37-45 dB(A)
A 1.5 m power cord with a thee pin plug is supplied. The power cord passes
through a slot in the back left hand corner of the appliance.
High - 50 W
Standby - <3 W
Flame failure sensing system, pressure relief, overheat safety switch, air
temperature sensor, thermal fuse, overcurrent fuse, and spark detection.
Operated by using the basic IR remote to control flame height and fan
speed, or for more features, such as timers and thermostatic control, using
Rinnai's Wi-Fi fireplace controller app—Wi-Fi module purchased as an
optional accessory.
Approx. 64 kg
**
2
Colinear
Coaxial
Advertisement
Table of Contents
