Table of Contents
Advertisement
Specification
Specification summary
Input:
19-33 MJ/h
Output:
3.8-7.5 kW*
Efficiency:
80%
Heating area:
up to 116 m
Gas type:
NG or ULPG
A direct vent (natural draft) inbuilt
gas fireplace with a glass front and
convection fan (top discharge).
Operated with a remote control
(7-day programmable timer).
* Will vary according to gas type and flue
configuration
** Will vary depending on geographical
location in NZ
Data plate
Centre front of base panel, behind
the service panels.
Gas connection
½ " BSP male flare. This connects
straight into the gas control on the
lower left hand side of the unit.
Dimensions (mm)
440
Cover panel: 150 mm opening on both sides of the heater. Covers are removed only when a Symmetry
Heat Transfer Kit is installed.
Standard metal outer frame
4 | RDV3611 installation guide: 11156-E 05-16
Ignition
Integrated sparker to pilot.
Noise level: 37-45 dB(A)
2
**
Flue
Inner 100 mm, outer 170 mm.
Appliance must be installed with a
Rinnai flue system.
Power consumption and
electrical supply
High
Standby
Comes with a 1.5 m power cord and
3-pin plug. The standard electrical
connection is to the right hand
side of the appliance.
Safety devices
Light to pilot, delayed ignition,
overheat switch, electronic
flame failure supervision, and
combustion chamber relief.
995
890
C L
1060
1006ID
1110
Temperature control
Thermostatic, temperature control
range 7-32 °C.
Weight: 60 kg
Installation considerations
Maximum flue height is 5.4 m.
Smaller rooms will heat up quickly,
and due to the efficiency of the
appliance, the fire will turn off
once the set temperature has been
50 W
reached.
<1 W
The Symmetry looks and performs
best when installed close to
the floor. If the unit is installed
higher up the wall the movement
of air from the convection
fan, depending on the room
configuration, could create
draughts.
1090
715
Premium flat metal outer frame
1155
190
Advertisement
Table of Contents
