Specification - Rinnai Neo RIB2311L Installation Manual

Specification

Neo
Natural draft burning log effect inbuilt gas fire
with glass front and convection fan. Different
frame options available.
Choose from either the electronic timer remote
model (ETR), which lets you preset the warmth
to come on at any time, or the manual control
model for push button operation.
Specification summary
Input = 14-30 MJ/h*
Output = 2.98-6.94 kW*
Efficiency = 80%
Energy star = 4.1 stars*
Heating area = 69-107 m
Gas type = NG or ULPG
* Will vary according to gas type and flue configuration
** Will vary depending on geographical location in NZ
Suitability
- Inbuilt masonry
- Inbuilt mock chimney
- Freestanding
The Neo is not suitable for areas where painting
is taking place, or in places such as hairdressing
salons, where there may be fluff and dust, and
where aerosols are used. The inbuilt Neo gas
fireplace models are not designed to be built
into bookcases.
Installation considerations
The Neo draws air for combustion from the room.
Adequate ventilation must be calculated and
provided by the gasfitter as per AS/NZS 5601.1.
Burn media
Driftwood log set comes as standard.
Convection fan
Fan forced 2-speed convection fan (low and
high). Heat is distributed from the top of the
appliance.
Data plate
Inside appliance on the front left hand side.
2 **
Gas connection
½ " BSPT. The gas supply terminates inside the
heater at the lower front right hand side of the
appliance.
Ignition
Continuous spark electronic ignition.
Noise level
37-45 dB(A)
Flue (masonry)
Rinnai recommends the use of a Rinnai flexiliner
flue (Ø 100 mm).
Flue (mock chimney and freestanding)
Inner 100 mm, outer 150 mm. Appliance must be
installed with a Rinnai flue system.
Power consumption and electrical supply
High = 50 W
Standby = < 3 W
Comes with a 1.5 m power cord and 3-pin plug.
The standard electrical connection is to the rear
left of the appliance, but can pass through the
left or right by removing the knockout tab from
the bottom edge of the front panel.
Safety devices
Overheat switch, electrical fuse, and flame failure
sensing system.
Temperature control
- Manual models
Manual control on the side of the unit.
- ETR models
Thermostat control. Temperature control
range 7-32 °C. The lower temperature range
is for cooler climates where the room
temperature could fall below 7 °C.
Weight
60 kg
Neo installation guide: 11906-H 08-15 | 5