Table of Contents
Advertisement
Wi-Fi module installation (if applicable)
If the Wi-Fi module retrofit kit has been purchased as an accessory, complete the installation using
the instructions provided in the kit. Once installation has been completed check, when the power is
on, that the Wi-Fi LED flashes and turns a solid red. This indicates everything is ready for setup via
a smart device. Go through the app sequence with the homeowner.
If unable to connect, the Wi-Fi board must be reset.
The reset button is a small hole in the base of the
board, underneath the LED. Using a paper clip
or similar, press and hold the reset button for 10
seconds.
Frame installation
Before installing the frame make sure the ON/OFF button on the PCB control panel is in the
OFF position, otherwise the button on the frame will not work.
IMPORTANT
1. Ensure the CAT5 cable is installed
into the ON/OFF button on the
frame and clipped in place in the
front of the fire.
2. Fit the frame over the top flange of
the fire.
3. Fix the frame to the fire using the
two supplied black M4 screws
(circled). It is CRITICAL to the safe
operation of the fire that these
screws are in place as this seals the
fire.
4. Fit the inner frame to the fire by
setting it into the allocated slot of
the outer frame and sliding it down.
5. On the PCB control panel, return
the button to the ON position.
Check the operation of the ON/OFF
button on the frame and that the
remote control is working.
1
2
1. Wi-Fi LED
2. Wi-Fi module reset hole position
Novo freestanding installation guide: 13992-A 01-22 | 25
Advertisement
Table of Contents
