Table of Contents
Advertisement
Novo Freestander and plinth installation
1. Mounting area and mounting plate
•
Mark the flue centre on the floor.
•
Place the base mount panel on the floor and line up with the centre marks, and mark the area
for power and gas to enter. The alternate power and gas options shown in the cube installation
also apply here.
•
Check there is sufficient timber under the screw mounting holes to provide the required seismic
restraint. If necessary, underfloor blocking may be required. A minimum of four screws, two
front and back, are required. Each fixing must be capable of withstanding a pull force of
at least 1.5 kN . A 10 ga screw 35 mm into solid timber or an 8 mm dynabolt masonry type
fastener would be suffice.
Power
supply entry
368 mm
18 | Novo freestanding installation guide:13992-A 01-22
Support rail x2
Underside cover x2
Side panel x2
Base mount plate
Base cover plate
Flue
centre
Gas
supply entry
Screw pack (36 screws)
Front panel
Fire
Footprint
Flexi tube
Tube connector
Back outer panel
Advertisement
Table of Contents
