– (1) Front panel cable to connector "FRONTPANEL1".
– (2) Front USB cable to connector "USB3.0 FRONT".
Ê If applicable, connect the cables of the ODD:
– ODD power cable to connector X17 on the backplane, see section
"Connecting a 3.5-inch HDD backplane" on page
– ODD SATA cable to connector SATA ODD on the system board.
Ê If applicable, install the expansion card in slot 4, see section
expansion cards" on page
I
For the cable plan, see chapter
Ê Carefully pull the front panel module into its bay and regard that the locking
mechanism snaps in (see circle).
V
CAUTION!
Ensure that none of the cables are strained or damaged.
13.3.1.6 Concluding steps
"Installing the fan holder" on page 64
Ê
"Installing the air duct" on page 62
Ê
"Reassembling" on page 55
Ê
"Connecting the power cord" on page 59
Ê
"Switching on the server" on page 60
Ê
"Verifying system information backup/restore" on page 74
Ê
Ê Store your server's system information on the Chassis ID EPROM
integrated into the front panel board. For more information on how to obtain
and use the ChassisId_Prom Tool, see section
Tool" on page
"Resuming BitLocker functionality" on page 89
Ê
RX2520 M4
207.
93.
Upgrade and Maintenance Manual
"Appendix B" on page
"Using the Chassis ID Prom
Front panel
173.
"Installing
411.
329