Concluding Steps - Fujitsu PRIMERGY RX2520 M4 Upgrade And Maintenance Manual

Hard disk drive (HDD) and solid state drive (SSD)
Figure 90: Connecting the SAS expander board to the RAID controller
Ê Connect the SAS cables to the SAS expander board:
– (1) from SAS controller connector "MLC1" to connector "X1"
– (2) from SAS controller connector "MLC2" to connector "X1"
Ê If applicable, connect the OOB cable to connector "X11" on the backplane
(3).
7.4.9.6

Concluding steps

"Installing the fan holder" on page 64
Ê
"Installing the air duct" on page 62
Ê
"Reassembling" on page 55
Ê
Ê Install all removed HDD modules, see section
module" on page
I
Make sure that you install the HDD/SSD module again in the bay it
was located before the backplane replacement.
"Connecting the power cord" on page 59
Ê
"Switching on the server" on page 60
Ê
"Resuming BitLocker functionality" on page 89
Ê
182
163.
Upgrade and Maintenance Manual
"Installing a 3.5-inch HDD
RX2520 M4